You may need to change the following settings to allow the Public
IP address assigned to you by the carrier to be used by an attached device. The
settings are labeled as "Public" mode and "Private" mode in
the modem LAN settings. Public Mode will provide the carrier assigned IP
settings directly to an attached client device though the modem Ethernet port
transparently. This mode will only support one Ethernet client device and
disables all routing and firewall functionality on the modem.
AceManager Web
- Connect to the modem with AceManager Web. Navigate to the LAN tab
- From the DHCP Addressing section, choose the drop down box on the Host Connection Mode and select Ethernet Uses Public IP
- Set the Public Mode Subnet Mask to 255.255.255.0
- Apply the change to the modem and re-boot
The modem will now pass addressing information from the carrier to an
attached device set to accept DHCP. Because of the difference in Ethernet chip
sets and possible synchronization issues, we recommend to "Hard code"
the IP settings provided by the modem in the Ethernet settings of client
devices.
UPDATE: To configure IP Passthrough for a gateway on newer ALEOS firmware (4.8.x), click here.
Related Posts
Links of Interest
UPDATE: To configure IP Passthrough for a gateway on newer ALEOS firmware (4.8.x), click here.
Related Posts
Links of Interest
